-\r
-/*---------------------------------------------------------------------------------------------------------------------------------------------------\r
- * Change settings from 1 to 0 if you want to disable one or more decoders.\r
- * This saves program space.\r
- * 1 enable decoder\r
- * 0 disable decoder\r
- *---------------------------------------------------------------------------------------------------------------------------------------------------\r
- */\r
-#define IRMP_SUPPORT_SIRCS_PROTOCOL 1 // flag: support SIRCS uses ~100 bytes\r
-#define IRMP_SUPPORT_NEC_PROTOCOL 1 // flag: support NEC + APPLE uses ~250 bytes\r
-#define IRMP_SUPPORT_SAMSUNG_PROTOCOL 1 // flag: support Samsung + Samsung32 uses ~250 bytes\r
-#define IRMP_SUPPORT_MATSUSHITA_PROTOCOL 1 // flag: support Matsushita uses ~50 bytes\r
-#define IRMP_SUPPORT_KASEIKYO_PROTOCOL 1 // flag: support Kaseikyo uses ~50 bytes\r
-#define IRMP_SUPPORT_RECS80_PROTOCOL 1 // flag: support RECS80 uses ~50 bytes\r
-#define IRMP_SUPPORT_RC5_PROTOCOL 1 // flag: support RC5 uses ~250 bytes\r
-#define IRMP_SUPPORT_DENON_PROTOCOL 1 // flag: support DENON uses ~250 bytes\r
-#define IRMP_SUPPORT_RC6_PROTOCOL 1 // flag: support RC6 uses ~200 bytes\r
-#define IRMP_SUPPORT_RECS80EXT_PROTOCOL 1 // flag: support RECS80EXT uses ~50 bytes\r
-#define IRMP_SUPPORT_NUBERT_PROTOCOL 1 // flag: support NUBERT uses ~50 bytes\r
-\r
-/*---------------------------------------------------------------------------------------------------------------------------------------------------\r
- * Change hardware pin here:\r
- *---------------------------------------------------------------------------------------------------------------------------------------------------\r
- */\r
-#ifdef PIC_CCS_COMPILER // PIC CCS Compiler:\r
-\r
-#define IRMP_PIN PIN_B4 // use PB4 as IR input on PIC\r
-\r
-#else // AVR:\r
-\r
-#define IRMP_PORT PORTB\r
-#define IRMP_DDR DDRB\r
-#define IRMP_PIN PINB\r
-#define IRMP_BIT 6 // use PB6 as IR input on AVR\r
-\r
-#define input(x) ((x) & (1 << IRMP_BIT))\r
-#endif\r
-\r
-/*---------------------------------------------------------------------------------------------------------------------------------------------------\r
- * Set IRMP_LOGGING to 1 if want to log data to UART with 9600Bd\r
- *---------------------------------------------------------------------------------------------------------------------------------------------------\r
- */\r
-#define IRMP_LOGGING 0 // 1: log IR signal (scan), 0: do not (default)\r