*\r
* Copyright (c) 2010 Frank Meyer - frank(at)fli4l.de\r
*\r
- * $Id: irmpconfig.h,v 1.11 2010/06/08 23:34:14 fm Exp $\r
+ * $Id: irmpconfig.h,v 1.21 2010/06/14 22:01:49 fm Exp $\r
*\r
* ATMEGA88 @ 8 MHz\r
*\r
*---------------------------------------------------------------------------------------------------------------------------------------------------\r
*/\r
#ifndef F_INTERRUPTS\r
-#define F_INTERRUPTS 10000 // interrupts per second\r
+#define F_INTERRUPTS 10000 // interrupts per second, min: 10000, max: 15000\r
#endif\r
\r
/*---------------------------------------------------------------------------------------------------------------------------------------------------\r
#define IRMP_SUPPORT_BANG_OLUFSEN_PROTOCOL 1 // flag: support Bang & Olufsen uses ~200 bytes\r
#define IRMP_SUPPORT_GRUNDIG_PROTOCOL 1 // flag: support Grundig uses ~150 bytes\r
#define IRMP_SUPPORT_NOKIA_PROTOCOL 1 // flag: support Nokia uses ~150 bytes\r
+#define IRMP_SUPPORT_FDC_PROTOCOL 0 // flag: support FDC3402 keyboard uses ~100 bytes\r
+#define IRMP_SUPPORT_RCCAR_PROTOCOL 0 // flag: support RC car uses ~150 bytes\r
\r
/*---------------------------------------------------------------------------------------------------------------------------------------------------\r
* THE FOLLOWING DECODERS WORK ONLY FOR F_INTERRUPTS > 14500!\r
*/\r
#if F_INTERRUPTS >= 14500\r
#define IRMP_SUPPORT_SIEMENS_PROTOCOL 1 // flag: support Siemens Gigaset uses ~150 bytes\r
-#define IRMP_SUPPORT_FDC_PROTOCOL 1 // flag: support FDC keyboard uses ~150 bytes\r
#else\r
#define IRMP_SUPPORT_SIEMENS_PROTOCOL 0 // DO NOT CHANGE! F_INTERRUPTS too low!\r
-#define IRMP_SUPPORT_FDC_PROTOCOL 0 // DO NOT CHANGE! F_INTERRUPTS too low!\r
+#endif\r
+\r
+#if IRMP_SUPPORT_FDC_PROTOCOL == 1 && IRMP_SUPPORT_RC5_PROTOCOL == 1\r
+#error Protocols RC5 and FDC may not be enabled both at the same time. Please disable one of them in irmpconfig.h.\r
+#endif\r
+\r
+#if IRMP_SUPPORT_RCCAR_PROTOCOL == 1 && IRMP_SUPPORT_RC5_PROTOCOL == 1\r
+#error Protocols RC5 and RCCAR may not be enabled both at the same time. Please disable one of them in irmpconfig.h.\r
#endif\r
\r
/*---------------------------------------------------------------------------------------------------------------------------------------------------\r
* Set IRMP_LOGGING to 1 if want to log data to UART with 9600Bd\r
*---------------------------------------------------------------------------------------------------------------------------------------------------\r
*/\r
-#define IRMP_LOGGING 0 // 1: log IR signal (scan), 0: do not (default)\r
+#ifndef IRMP_LOGGING\r
+#define IRMP_LOGGING 0 // 1: log IR signal (scan), 0: do not (default)\r
+#endif\r
\r
#endif /* _WC_IRMPCONFIG_H_ */\r